top of page

DOLRE H2: very low ULS forces, clean design, tested on anchored and non-anchored beams

The lowest ULS forces on the market

​​

DOLRE H2 is a restraint system specifically designed to considerably limit the stresses it generates in the supporting structure.

​

The CE-certified restraint system controls the transmitted forces thanks to a patented fuse system located outside the concrete and outside the anchorages. This fuse:

​

  - Protects the anchorages and the concrete after an accident

  - Allows quick replacement of the post only.

​

​

​

​

​

​

​

​

​

​

​

​

​

​

​​
DOLRE features a robust design of the above-ground elements, with 3 thick-walled tubes over a height of 1.2 m, giving optimal load distribution across several posts.

Key figures:


- Moment M: 11 kN·m at the base of the post.
- Shear force V: 44 kN at the base of the post.

​

​​​​​​​​​​​​​​​​​​​​​​​​​​​​​

​

image.png
image.png

A Distinctive Design

Crash-Tested on Anchored and Non-Anchored Beams

DOLRE H2 has been successfully tested 4 times.

​

Several crash tests were carried out to demonstrate safely that the barrier can be installed on non-anchored beams and in different configurations, to make the works easier to carry out.

The flexible design of DOLRE H2 and the way its patented fuse on the base plate works allowed us to consider, and rigorously test, its real behaviour on non-anchored beams.

TRANSPOLIS H2 TB51 test #1

​

Beam anchored to the deck

15 cm thick (15 cm visible kerb)

50 cm wide

​​

​

=> W4 = 1.3 m

=> Vi3 = 1m​​​

TRANSPOLIS H2 TB51 test #2

​

Non-anchored, non-embedded beam

Cast on asphalt with a rear stop

15 cm thick (15 cm visible kerb)

65 cm wide

​

=> W3 =1m

=> Vi3 = 1m

​​​

TRANSPOLIS H2 TB51 test #3

​

Non-anchored, non-embedded, bonded beam without a stop.

15 cm thick (15 cm visible kerb)

65 cm wide

​​

​

=> W3 =1m

=> Vi3 = 0.9 m

​​

TRANSPOLIS H2 TB51 test #4

​

Non-anchored, embedded, non-bonded beam with a stop.

25 cm thick (15 cm visible kerb)

50 cm wide

​​

=> W4 = 1.2 m

=> Vi4 = 1.3 m

​

​

​​​

conditions d'essais
bottom of page